Ore

Jaw Crusher PULVERISETTE 1 classic line Model I

gap position:4

crushing jaws made of hardmetal tungsten carbide (WC)

Optional, crushing jaws can be equipped in e.g. stainless steel, manganese steel, zirconium oxide,…

With gap position 4, sample can be ground very fast. Pieces up to 2,5cm can be found afterwards.

After the total amount of sample has been ground this way, sample will be fed a second time with smallest gap setting (position 1 – see result 2).

In total, we are guessing that a grinding in two steps (as shown), will save a bit of time.

Jaw Crusher PULVERISETTE 1 classic line Model I

gap position:1

crushing jaws made of hardmetal tungsten carbide (WC)

After pre grinding in result 1 to < 2,5cm, about 36g as desired have been fed a second time with smallest gap position.

After 5 seconds, the 36g of sample have been ground to < 9mm. Jaws use to be free of residue. A grinding of higher amounts should be possible without any problems.

Sample will be fine ground in result 3.

Planetary Mono Mill PULVERISETTE 6 classic line

main disk speed: 600 rpm

250 ml grinding bowl made of zirconium oxide (ZrO2)

+15x 20 mm Ø ZrO2 grinding balls

Higher amounts of sample might get pre ground in gap position 1 with our Jaw crusher and complete sample < 9mm should be divided with e.g. Rotary Cone Sample Divider LABORETTE 27 (with ratio 1:8 or 1:10).

Afterwards, sampling will be much more precise and reproducible.

Even higher amounts of sample can be ground in one bowl of 250ml volume.

After 2 minutes of grinding, fineness has been checked with our Vibratory Sieve Shaker ANALYSETTE 3 Pro by sieving out an aliquot. All sample got ground to < 150µm as desired. Longer grinding time is still possible to achieve a better endfineness.